Brochure
High Power Design Services Powered by Arrow Swindon CoE
Executive Summary The High-Power Center of Excellence (CoE) of Arrow
August 1, 2025
No Comments
Services Category: Physical Design & DFT
Brochure
Analog & Mixed-Signal Design Services
Executive Summary Powering Precision from Concept to Silicon Designing advanced
July 30, 2025
No Comments
Blog
Understanding PERC: Definition and Applications for Reliable Design
Introduction PERC is an abbreviation of programmable electrical rules checking.
July 15, 2025
No Comments
Case Study
DFT – Industrial Ethernet Switch
Case Study – Elevate your industrial connectivity with cutting-edge semiconductor technology. Discover our Real Time Ethernet Switch supporting major protocols…
February 1, 2024
No Comments
Whitepaper/Publications
A Guide on Logical Equivalence Checking
White Paper – This paper gives an introduction of logical equivalence check, flow setup, steps to debug it, and solutions to fix LEC…
March 26, 2019
No Comments
Case Study
Physical Design of Data Center ASIC
Case study – How we helped a niche data center infrastructure start-up with the Physical Design of an Innovative Data Center ASIC…
February 28, 2019
No Comments
Whitepaper/Publications
A Complete Guide to Chatbot Development – From Tools to Best Practices
Executive Summary With the exponential increase in the IoT and
September 25, 2018
No Comments
Case Study
Design for Testability (DFT) of a Motion Control MEMS ASIC
End-to-End Design for Testability (DFT) of a Digital Motion Control MEMS ASIC – DFT architecture defining to post-silicon support…
October 30, 2017
No Comments
Case Study
Design for Testability for a High-speed Gigabit Ethernet Controller for Networking
ASIC design and DFT solution for a Gigabit Ethernet Controller at 28nm technology node to enable high-performance …
September 18, 2017
No Comments
Whitepaper/Publications
Physical Design Implementation Challenges in Highly Memory-Intensive Design in 40 nm
Memory-intensive blocks with vivid aspect-ratio memory lead to tight challenges in floor planning to placement…
June 10, 2016
No Comments
